Carrier tape tensile testing machine need to pay attention to what issues

Carrier tape tensile testing machine is also electronic tensile testing machine, electronic tensile testing machine installed in a clean and dry and uniform temperature of the house at the same time should be considered in the machine for a longer long beam bending test and the possibility of using the mirror extension meter for the test, so the test machine should be left with sufficient free area around.

Carrier tape tensile testing machine in the installation and use of some attention

Carrier tape tensile testing machine in and handling process to pay extra attention to, because the tensile testing machine testing data requirements for accurate, so the tensile testing machine either in transport or installation, use, do not carry out violent collisions, so as not to affect the test results.

Carrier tape tensile testing machine in the installation should pay attention to

1. In an environment with little room temperature and relative humidity.
2. Tensile testing machine is installed correctly.
3. No corrosive media around.
4. Power supply voltage fluctuations are not large
5. The host must be grounded.

Carrier tape tensile testing machine in use need to pay attention to the place

First, the tape tensile testing machine do not frequently switch on and off

In the daily use of electronic tensile testing machine can not be randomly switch the test machine host power, if the frequent opening of the machine will lead to damage to the AC servo motor drive, and is will affect the life of the drive, in which we close the host power 1 minute before you can turn on again, so in the daily use of the electronic testing machine needs to minimize the number of times the switch.

Second, the carrier tape tensile testing machine equipment should not be used for a long time

Some users do not have the need to test information at the time, the equipment is placed for a long time without use. But a long time will affect the internal electrical parts of the equipment and transmission parts of the service life, so the test machine in the factory will communicate with the user, in the equipment idle cycle beyond a week, should be turned on the equipment to stop the warm-up 1 minute, and then up and down in the operation of the beam, so that the experimental equipment to fully reach the smooth, so that it can also improve the service life of the equipment and precision.

Third, the carrier tape tensile testing machine experimental process operation is not standard

In the course of the experiment will often encounter clamping specimen interval time is short, in our choice of speed above the need to follow the electronic tensile testing machine manufacturers operating procedures, if once the speed is too fast, not able to abort in time, so it will lead to impact force sensor, just force sensor damage. After each experiment requires the implementation of electronic universal testing machine cleanup, because in doing metal materials or non-metallic information with the specimen stretching, there will be some ministry debris scattered, if not timely cleanup, will fall into the jaws of the clamped specimen, over time will cause serious wear and tear of the jaws, after each clean need to clean the jaws and cut grease.

We also need to pay attention to the use of carrier tape tension testers:

Pay attention to whether the beam is running normally

Pay attention to the speed of each run is smooth

Pay attention to the running distance, whether the overshoot.

Pay attention to the tape and tension is in the normal range.

Pay attention to whether the panel display is normal or not.

Pay attention to whether the panel key function is normal.

Pay attention to whether the reducer under the working table is working normally

Pay attention to whether the bearings at the upper and lower ends of the screw are normal

Pay attention to whether the screw and filament are loose

Pay attention to the load carrier tape tensile testing machine, compression limited space is large enough

Pay attention to the effective spacing of the carrier tape tensile testing machine to meet the requirements

Pay attention to the carrier tape tensile testing machine table is clean and tidy

Pay attention to the sensor appearance whether there is damage pay attention to the motor whether there is noise noise

Carrier tape tensile testing machine is widely used, rubber, plastic, metal or non-metal materials are used to test the machine. Tape tensile testing machine and ordinary equipment is the same as the service life, but if you maintain a good use of the right method with a dozen years is no problem. Many of our old customers bought back more than ten years of equipment is still in use without any problems, because these old customers of equipment maintenance in all aspects are very well in place, which greatly increases the service life.